Zhejiang Shengtai Electronic Co Ltd

Model Number: ST-EPS021-#4248 Brand Name: Shengtai Key Specifications/Special Features: Input: 100-280V AC/50-60HZOutput: 20-60VDCDimensions: 260*60*60mmEmergency pack:DF168-30HBattery pack NIMH 12V2800mAh and 400g

Weight: 1.26kg

Packing:

• Carton size: 47*33*10mm
• Quantity: 8 pieces per carton

Charging time: 24 hours

Duration time: 90 minute

Conversion efficiency:90%

Power factor:90%

Emergency switching time: 1S

Lighting system continuous

Service life 30,000 hours

Humidity range:65 ±20%

Installation and operation instruction:

• Connect firewire L+ LED external drive fire wire input
• This line can set a wall switch S
• Wall switch only controls the main power, no function on emergency lighting
• Connect the zero line N + LED external drive zero line input
• One line connect with the other side of wall switch S, enter the fire wire port,one line connect with LED drivefirewire
• ConnectLED driveoutput positive
• Connect light sourcenegative +light source external driveoutput negative
• Light positive

Note:

• Accordance with writing diagram to connect the circuit in strictand pay attention to distinguish between the zero line and fire wire
• Forbid connecting line when the mains and wiring by professional electrician
• Should cut offthe mains then wiring
• Mainpowerline:firelineLandzerolineN,connectto mainpowerlinedirectly
• No switch can be allowed when emergency lighting
• Law forbids the switch control emergency circuit
• Wall switch only controls the main power andno function on emergency lighting
• Green light-main power, red light-charging and yellow light multiplefunction
• Emergency lighting condition andthree-color light is all out
• Digital circuits, self-test function (monthly inspection andannual inspection), fault or automatic alarm function cause by illegal operation
• Emergency core module is a device which controls the battery charging and dischargingand start lights illumination
• Sure the wiring is correct before your run our products
• In normal use of electricity, it should discharge once every three months for battery conservationand to extend battery life
• After the emergency lights power installation into use, there should set a special position for regular inspection and maintenanceand be timely maintenance or notify the supplier whenabnormal situation was found